SMART EVO 2

Informazioni

SMART EVO 2

Technical features

  • Single phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO Mono);
  • Three phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO -Tri);
  • Three phase power supply 310-450Vac ±10% 50/60Hz (SMART EVO -Tri);
  • G/P1 and G/P2 normally open inputs for start-up command;
  • 3 inputs for single-pole level sensors (COM-MIN-MAX);
  • T1 and T2 input...

Technical features

  • Single phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO Mono);
  • Three phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO -Tri);
  • Three phase power supply 310-450Vac ±10% 50/60Hz (SMART EVO -Tri);
  • G/P1 and G/P2 normally open inputs for start-up command;
  • 3 inputs for single-pole level sensors (COM-MIN-MAX);
  • T1 and T2 inputs for motor clicson;
  • Normally open input for alarm activation;
  • AUTOMATIC-0-MANUAL buttons (spring return);
  • DIP-SWITCH selectors for:
    • level alarm enable from sensors,
    • thermal cut-out activation delay 5/10 seconds,
    • alarm output settings,
    • alarm reset enable from motor clicson,
    • Filling/Emptying mode,
    • start/stop float enable,
    • enable of delay on board activation on power mains return,
    • motor switching module enable (on SMART EVO 2);
  • Green led: power ON  / failure or incorrect phase sequence;
  • Green leds: automatic mode enabled;
  • Green led: motor active;
  • Red led: level alarm from sensors or GA input;
  • Red leds: motor overload alarm/minimum current alarm;
  • Red leds: motor clicson activation alarm;
  • Electronic control of maximum current due to overload, with assisted calibration;
  • Electronic control of minimum current due to dry run, with assisted calibration;
  • Automatic reset due to minimum current alarm;
  • Protections of auxiliary circuits and motor with fuses;
  • Cumulative alarm output with voltage-free contacts (COM-NO-NC resistive load - 5A / 250V);
  • Cumulative alarm output, live (12Vcc / 100mA);
  • Door lock general disconnect switch;
  • Provision for start-up capacitors, single phase version (not included);
  • Box in ABS, IP55;
  • Ambient temperature: -5/+40 °C;
  • Relative humidity 50% at 40 °C (condensate free).

More

SMART EVO 2 There are 5 products.

Showing 1 - 5 of 5 items
Showing 1 - 5 of 5 items